Rebar calculator

Enter the slab size, grid spacing and how far the bars stop short of the edges. The calculator lays out the grid both directions.

Rebar to buy

11 20 ft bars

Linear feet
190 ft before extra
Bars running lengthwise
10 at 9.5 ft
Bars running widthwise
10 at 9.5 ft
Grid intersections to tie
100 ties

Shop for this project

As an Amazon Associate, Measure the Dream earns from qualifying purchases.

How it works

The bars stop short of each edge by the clearance you enter, so concrete fully covers them. The calculator counts how many bars fit across the slab at your spacing (in both directions), multiplies by each bar’s length, and divides the total by your stock bar length. The extra percentage covers overlaps where bars are spliced and cutting waste.

Example

With slab length 10 ft, slab width 10 ft, grid spacing 12 in, edge clearance 3 in, bar length: 20 ft bars, extra for laps and cuts 10%, the answer is 11 20 ft bars.

How to measure

Measure the slab’s length and width and decide on spacing. A grid every 12 to 18 inches is common for patios and driveways; footings and structural slabs should follow your plans or local code.

The calculator keeps the bars 3 inches in from every edge so they stay covered by concrete, then counts the bars each way and the ties where they cross.

20 ft rebar bars by slab size and spacing

3 inches of edge cover and 10% extra.

Slab size12 in grid16 in grid18 in grid
10 × 10 ft1198
12 × 12 ft161211
12 × 20 ft262018
20 × 20 ft433331
24 × 24 ft634742

Common mistakes

  • Laying rebar on the ground. It needs to sit in the middle of the slab’s thickness on chairs or concrete blocks, or it does almost nothing.
  • Butting bars end to end. Where bars join, overlap them; a common rule is about 40 times the bar diameter, roughly 20 inches for #4 bar.
  • Running bars to the very edge. Keep about 3 inches of concrete around the steel so it doesn’t rust.
  • Skipping control joints. Rebar holds cracks tight, but the slab still needs joints to crack along.

Tips before you buy

  • Support rebar on chairs or blocks so it sits in the middle of the slab, not on the ground.
  • Where bars splice, overlap them generously and tie them together. Your plans or local code set the exact lap length.
  • Many residential slabs use #3 or #4 bar on a 12 to 18 inch grid, but follow your plans or engineer.

Common questions

How much rebar for a 10×10 slab?

On a 12 inch grid with 3 inches of edge clearance, 10 bars each way at 9.5 feet, or 190 linear feet. That’s 11 bars of 20 ft stock with 10% extra.

How far apart should rebar be in a slab?

12 to 18 inches each way is common for residential slabs. Your plans or local code have the final say.

How far from the edge should rebar stop?

Typically about 2 to 3 inches, so the steel is fully covered by concrete.

Add this calculator to your website

Free for any site or blog. Paste this code where you want the calculator to appear. The short script makes it resize to fit; if your site doesn’t allow scripts, the calculator still works without it.