Deck board calculator

Enter the deck size, board width and gap. The calculator counts rows, boards and the screws to fasten them.

Measuring in meters? Use the metric version

Deck boards

29 16 ft boards

Rows of boards
26 rows
Linear feet
416 ft before waste
Deck screws
676 screws (2 per joist)
Deck area
192 sq ft

Shop for this project

As an Amazon Associate, Measure the Dream earns from qualifying purchases.

How it works

Each row of decking takes up one board width plus one gap. The calculator divides the deck width by that to count rows, multiplies rows by the deck length to get linear feet, adds waste, and divides by your board length.

Screws assume two per board at every joist. If you use hidden fasteners, count clips with the manufacturer’s coverage chart instead.

Example

With deck length (direction boards run) 16 ft, deck width (across the boards) 12 ft, board width: 5½ in (5/4×6 or 2×6), gap between boards 0.125 in, board length: 16 ft, joist spacing: 16 in on center, waste 10%, the answer is 29 16 ft boards.

How to measure

Measure the deck’s length and width, and note which way the boards will run. Boards almost always run across the joists, so on a typical deck they run parallel to the house.

Pick a board length that covers the deck in one piece if you can, or that breaks evenly over the joists. A 16 ft deck with 16 ft boards has no joints, while a 14 ft deck with 16 ft boards wastes 2 ft per row.

Deck boards by deck size

5½ inch wide boards, ⅛ inch gaps, joists 16 inches apart and 10% extra.

Deck sizeBoards (length = deck length)Deck screws
10 × 10 ft25352
12 × 12 ft29520
12 × 16 ft29676
16 × 20 ft391,120
20 × 20 ft481,376

Common mistakes

  • Ignoring the gap spec for composite boards. Composite and PVC decking need specific gaps for expansion that depend on temperature at install time. Follow the manufacturer’s chart.
  • Joining boards between joists. Every butt joint has to land on a joist, and two boards meeting on one joist often need extra blocking.
  • Forgetting fascia and picture framing. Boards around the edge and on the rim joist are a separate count.
  • Using the wrong fasteners. Pressure-treated lumber corrodes plain steel, so use coated or stainless deck screws rated for it.

Tips before you buy

  • Pick a board length that lets seams land on joists, and stagger seams from row to row.
  • Wood decking is often installed tight or with a small gap, because it shrinks as it dries. Composite boards have a required gap; follow the manufacturer.
  • Many composite boards need joists at 12 inches on center, especially on diagonal layouts.
  • Buy a few extra boards so you can skip ones with ugly knots or a bad crown.

Common questions

How many deck boards for a 12×16 deck?

With 5½ inch boards running the 16-foot direction and a 1/8 inch gap, about 29 boards at 16 feet, including 10% waste.

What gap should deck boards have?

Commonly 1/8 to 1/4 inch for dry lumber and composite. Wet pressure-treated wood is often installed tight because it shrinks.

How many screws do I need per square foot of deck?

With 5½ inch boards over joists at 16 inches, about 3.2 screws per square foot.

Add this calculator to your website

Free for any site or blog. Paste this code where you want the calculator to appear. The short script makes it resize to fit; if your site doesn’t allow scripts, the calculator still works without it.